Kenmore Washer 110.20022012 Suspension Spring Part Number

If your Kenmore washer is bouncing excessively or making loud noises during the spin cycle, the suspension springs may be worn out. For model 110.20022012, the correct suspension spring part number is 22002542 (or 22002541 for some variants, depending on the exact design). This article explains how to confirm your spring part number, where to buy it, and how to replace it safely.

Identifying the Correct Suspension Spring Part Number

The Kenmore washer model 110.20022012 uses two types of suspension springs: the upper coil springs and the lower rod-and-spring assemblies. The most commonly replaced spring is the lower suspension spring, part number 22002542. However, you should always verify using your machine's serial number and the manufacturer's parts diagram.

How to Confirm Your Model Number

Locate the model number sticker on your washer. It is usually found on the back panel or inside the lid. For model 110.20022012, the “110” prefix indicates manufacture by Whirlpool. Once you have the full model number, it is safe to assume the suspension spring part number is 22002542 for most units.

Alternative Part Numbers

• Upper suspension spring: part number 22002541 (used on some early production units).
• If your washer has a different suspension system, you may need a kit (part number 285785).

Check the current parts diagram at a reliable appliance parts website before ordering.

Ordering the Suspension Spring

You can purchase the Kenmore suspension spring part number 22002542 from several online appliance parts retailers. Avoid general marketplaces; instead, use specialized sites like Sears PartsDirect, RepairClinic, or PartSelect. These sites offer accurate fitment verification and often include installation instructions.

What to Look For

• OEM vs. aftermarket: OEM springs (Whirlpool/Kenmore) are recommended for longevity.
• Quantity: Usually two springs are needed (one per side).
• Price: Expect $10–$20 per spring.

Tools Needed for Replacement

• Flat-head screwdriver
• 1/4-inch nut driver or socket
• Needle-nose pliers (optional)
• Work gloves

Step-by-Step Suspension Spring Replacement

Safety First

Unplug the washer and turn off the water supply. Tilt the machine forward to access the bottom suspension area. Use a piece of wood or a helper to support the tub.

Accessing the Springs

1. Remove the front access panel (if applicable) by prying off the clips or removing screws.
2. Locate the suspension springs – they connect the top of the cabinet to the bottom of the wash tub.
3. For the lower springs, you will see a hook at the top attached to the tub and a hook at the bottom attached to the base.

Removing Old Springs

1. Use a flat-head screwdriver to pry the top hook off the tub bracket. Be careful not to damage the bracket.
2. Detach the bottom hook from the base. The spring may be under tension; wear gloves.
3. If the spring is broken, simply pull it out.

Installing New Springs

1. Hook the bottom of the new spring into the base bracket first.
2. Stretch the spring upward and hook the top into the tub bracket. Use pliers if needed.
3. Ensure both springs are installed symmetrically (left and right).

Reassembly

1. Replace the front panel or any removed panels.
2. Plug the washer back in and run a test cycle with an empty load.
3. Check for excessive movement or noise.

Final Recommendation

For a Kenmore washer model 110.20022012, order two OEM suspension springs part number 22002542 from a reputable appliance parts supplier. Replace both springs at the same time even if only one appears worn. This restores balance and eliminates noisy spinning. If you are uncomfortable with the repair, hire a professional appliance technician. Always verify your model number and refer to the manufacturer's diagram before purchasing parts.